ABR 50 Rust Remover

ABR 50 Rust Remover

Remove rust from metal surfaces and stains caused by iron deposits impregnated into surfaces with the proper chemical ions to transform rust into a composite of soda ash generally leaving a white haze film that may be easily washed and removed with water.

Coverage: 100-200 sq. ft. per gallon depending on the porosity of the surface being treated.

Category:

Description

ABR®-50 Rust Remover is formulated to remove rust from metal surfaces and stains caused by iron deposits impregnated into masonry.

ABR®-50 Rust Remover is recommended to clean rust runoff stains on masonry from adjacent metal surfaces and stained concrete walkways resulting from sprinkler systems containing water with heavy iron deposits.

ABR®-50 Rust Remover contains the proper chemical ions to transform rust into a composite of soda ash generally leaving a white haze film that may be easily washed and removed with water pressure.

Additional information

SURFACE PREPARATION:

A test area should be
performed prior to beginning overall project
to determine precise procedure necessary for
the most effective removal of rust or stain.
User shall determine the suitability of the
product for intended its use and assumes all
risk and liability whatsoever in connection
therewith.

APPLICATION:

Mechanically scrape away any
scaling or other external residue from
surface to be treated
2. ABR®-50 Rust Remover may be
diluted up to 1 part ABR®-50 Rust
Remover to 10 parts water.
Caution: using ABR®-50 Rust Remover
too strong will etch concrete.
3. Mix well before using.
4. Apply ABR®-50 Rust Remover
with an acid resistant brush or a low
pressure hand pump sprayer.
5. Completely saturate the surface to
be treated. Avoid puddling. Brush any
puddles into surface.
Removing rust from metal: Allow
ABR®-50 Rust Remover to stand for 35
minutes or longer as determined by test
procedures. Use pressure washer to rinse
with water to remove ABR®-50 Rust
Remover.
Removing rust from stone: Allow
ABR®-50 Rust Remover to dry completely
on surface (at least 24 hours). No rinse will
be required. However, if stain is still
evident, use pressure washer to rinse with
water before applying second coat of ABR®-50 Rust Remover.
Note: In treating a deep stain, repeat
process as often as necessary,
determined by test procedure. Be sure to
allow each application to dry
completely and then pressure rinse
before applying second coat.
6. To protect newly restored
surfaces from further rust damage,
follow-up the ABR®-50 Rust Remover
process with appropriate Hydro Seal™
waterproofer from ABRP, Inc.

Reviews

There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.

Title

Go to Top