X-190 Limestone & Concrete Cleaner

X-190 Limestone & Concrete Cleaner

  • Restores a new appearance to slightly dirty or discolored limestone, poured concrete, precast, poured aggregate and travertine.

COVERAGE: 150 to 200 sq. ft./gal.

Category:

Description

X-190 Limestone & Concrete Cleaner is used in restoring a new appearance to dirty or discolored limestone, poured concrete and walkways, pre-cast or poured aggregate, travertine and more. X-190 Limestone & Concrete Cleaner may be used as a bleach to whiten concrete or limestone. X-190 Limestone & Concrete Cleaner cleans without leaving yellow stains. X-190 Limestone & Concrete Cleaner is safe on glass and contains no hydrofluoric acid.

Additional information

SURFACE PREPARATION:

Fully protect all adjacent surfaces, especially aluminum. Do not allow
X-190 Limestone & Concrete Cleaner to splash or dry onto adjacent surfaces not intended for cleaning.
Immediately rinse with water upon contact. The use of breathing types of drop cloths to protect adjacent
plants and delicate vegetation is recommended. Vegetation which cannot be readily covered should
be sprayed with water before and after X-190 Limestone & Concrete Cleaner is applied. Beware of wind drift onto auto and pedestrian traffic when rinsing or applying X-190 Limestone & Concrete Cleaner. A test area should be performed on each type of surface prior to beginning overall project to
determine precise procedures necessary for most effective cleaning. User shall determine the suitability of the product for its intended use and assumes all risk
and liability whatsoever in connection therewith.

APPLICATION:

1. Apply X-190 Limestone & Concrete Cleaner either in full strength or diluted. May be
diluted up to 1 part X-190 Limestone & Concrete Cleaner to 2 parts hot water.
2. Mix well before using.
NOTE: Crystals forming in bottom of container will dissolve in hot water. This will not affect products
performance.
3. Apply X-190 Limestone & Concrete Cleaner with a brush or hand pump sprayer.
4. Let X-190 Limestone & Concrete Cleaner do most of the work by allowing it to stand on surface for
approximately 15 minutes or as determined by test procedures.
5. Deeper stains may require additional scrubbing with full strength X-190 Limestone & Concrete Cleaner. Scrub with a stiff, fiber brush from the bottom up.
6. Rinsing with a pressure washer
will make the job easier and faster. Always rinse from the top down.
7. To protect the surface, follow up the X-190 Limestone & Concrete Cleaner restoration process with a coating of appropriate ABRP, Inc
HydroSeal™ water repellent.

Reviews

There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.

Title

Go to Top