ABR® Glass De-Etcher and X-19 Glass Cleaner & Restorer

ABR® Glass De-Etcher and X-19 Glass Cleaner & Restorer

  • ABR® Glass De-Etcher is a polishing compound that removes hydrofluoric acid burn stains from glass.
  • X-19 Glass Cleaner & Restorer is an acidic blend of wetting agents and detergents especially formulated to restore glass surfaces.
  • ABR® Glass De-Etcher and X-19 Glass Cleaner & Restorer remove hard water marks and stains caused by run-off from unsealed masonry, airborne pollution and acid rain haze that causes oxidation to glass.

COVERAGE: De-Etcher–500 to 800 sq. ft./pint X-19–250 to 500 sq. ft./gal.

Description

ABR® Glass De-Etcher is a polishing compound that removes hydrofluoric acid burn stains from glass. X-19 Glass Cleaner & Restorer is recommended for use on glass surfaces that will not come clean with routine washing. X-19 Glass Cleaner & Restorer is an acidic blend of wetting agents and detergents especially formulated to restore glass surfaces. ABR® Glass De-Etcher and X-19 Glass Cleaner & Restorer remove hard water marks, stains caused by run-off from unsealed masonry, airborne pollution and acid rain haze that causes oxidation to glass.

Product Specifications
Material Safety Data

Additional information

SURFACE PREPARATION:

A test area of any ABRP, Inc. glass
product should be performed prior to beginning overall
project to determine precise procedures necessary.
User shall determine the suitability of the product
for its intended use and assumes all risk and liability
whatsoever in connection therewith.

APPLICATION:

X-19 GLASS CLEANER & RESTORER: 1. Severe scum
or stains may require using X-19 Glass Cleaner &
Restorer full strength. In most cases a solution of 1
part of X-19 Glass Cleaner & Restorer to 3 parts
water will produce excellent results. 2. Pre-wet
the glass area to be cleaned. 3. Apply X-19 Glass
Cleaner & Restorer with an applicator brush or poly
tank hand pump sprayer. 4. Allow X-19 Glass Cleaner
& Restorer to remain on glass area 1-2 minutes or
longer if necessary. 5. Rinse thoroughly with water. 6.
Squeegee glass or dry with a clean cloth.
ABR® GLASS DE-ETCHER: 1. Apply ABR® Glass DeEtcher
to glass using a dampened buffing pad on
an electric buffer at 1500 to 1700 RPM in a circular
motion—KEEP WET WHILE WORKING. 2. Continue
buffing until ABR® Glass De-Etcher becomes dry
and disappears. Re-dampen glass and/or buffing pad
with water and polish. Repeat process if necessary.
NOTE: Do not attempt to do this process by hand.
Proper results will not be obtained.

Reviews

There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.